GE EP Series Installation Guide download pdf

Lighting Solutions

imagination at work

Lumination

LED Luminaires

(Series EP14 + Lutron TVI-LMF-2A Eco)

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Save These Instructions

Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.

Installation Guide

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL or IEC approved wire for input/output connections.

Minimum size 18 AWG (0.75mm

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’inspecter, installer ou de retirer l’unité.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation

électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL pour les entrées/sorties de connexion.

Taille minimum 18 AWG (0.75mm

Prepare Electrical Wiring

Electrical Requirements

• The LED driver must be supplied with 120-277 VAC, 50/60 Hz and connected to an individual properly

grounded branch circuit, protected by a 15 or 20 ampere circuit breaker. Use Min. 75°C supply conductor.

Grounding Instructions

• The grounding and bonding of the overall system shall be done in accordance with National Electric Code

(NEC) Article 600 and local codes.

1 2 3 4 5 6

Summary of Contents

Page 1 - LED Luminaires

GELighting Solutionsimagination at workLuminationTM LED Luminaires(Series EP14 + Lutron TVI-LMF-2A Eco) BEFORE YOU BEGINRead these instructions comple

Page 2 - Electrical Connections

Wiring DiagramElectrical ConnectionsLutron Interface0-10VOutputGNDNSwitched Hot/OutConstant Hot/InEcoSystemDigital LinkPSUFIXTURELineNeutralDALIDALI/0

Page 3 - E1 and E2

5 6Connect AC line to black, white and green wires from Lutron interface with twist-on wire caps. Connect EcoSystem bus wires to the two purple Lutron

Page 4 - Unit Installation

Unit InstallationTo adjust height and to level a xture, squeeze the tip of the gripper and pull the suspension cable to the desired height. Clip the

Page 5

243On the 1st luminaire, disconnect the right-side suspension wire and “Y” shape suspension wire. Then on the 2nd luminaire, disassemble the left-side

Page 6 - Specications

IND049-121712GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com1 - 8 8 8 - 6 9 - 4 3 - 5 3 3GE Lighting Solutions, LLC is a subsi