7
1
Connect the ground wire from front cover to the ground
screw on the top plate. (Other wires hidden for clarity).
Put inter connector on the top of two luminaires and make
sure that the slot of the inter connector cross the two end
caps.
8
2
Put back the front cover. Push to get it snapped by two
end caps. Attached suspension cable and cords with
plastic clips provided.
Push the inter connector into the luminaires. Remove the
protective lm and insert the Light Guide clip between
the two Light Guides.
Light Guide clip
Luminaire Inter Connection and Alignment
B
DALI Controller
A
0-10 Volt Dimming
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation. This Class [A] RFLD complies with the Canadian standard ICES-003. Ce DEFR de la classe
[ A ] est conforme à la NMB-003 du Canada.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
IND081-101113
BLU/WHT
BLK/WHT
YEL
GRY
VIO
VIO/WHT
LED Driver
To DALI
Controller
DALI/Prog
DALI/Prog
BLU/WHT
BLK/WHT
YEL
GRY
VIO
VIO/WHT
LED Driver
To 0-10V
Dimmer
0-10V -
0-10V +
GE Lighting • 1-888-MY-GE-LED (1-888-69-43-533) • www.gelighting.com
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand, logo, Lumination are trademarks of the General Electric Company. USG and Logix are trademarks of USG Interiors, LLC.
© 2013 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Suspension cable
Plastic clip
Front cover
Driver box
Flexible cord
Optional Installation (For 120-277V and 347V Application): 0-10 Volt Dimming or DALI Lighting Controller. Follow gure A for 0-10V
and gure B for DALI. Run wires from controller through a different knockout than the AC input wire. At output side of LED Driver, make
appropriate connections using twist-on wire connectors. Follow lighting controller installation instructions.
Inter connector
(2 pages)
(4 pages)
(36 pages)
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals