GE ALC4 Installation Guide download pdf (Page 1)

Lighting Solutions

Installation Guide

imagination at work

Linear Lighting

(ALC4-series)

Features

• 5 year warranty

• Damp location rated

Albeo

LED Luminaire

Prepare Electrical Wiring

Electrical Requirements

• The LED driver must be supplied with 120-480 VAC, 50/60 Hz per product label and connected to an individual

properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker.

Grounding Instructions

• The grounding and bonding of the overall system shall be done in accordance with National Electric Code

(NEC) Article 600 and local codes.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL or IEC approved wire for input/output connections.

Minimum size 18 AWG.

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL ou IEC pour les entrées/sorties de

connexion. Taille minimum 18 AWG.

Save These Instructions

Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (A)/NMB-3(A)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the

interference at his own expense.

1 2 3 4 5 6

Summary of Contents

Page 1 - LED Luminaire

GELighting SolutionsInstallation Guideimagination at workLinear Lighting(ALC4-series)Features• 5 year warranty• Damp location ratedAlbeoTM LED Luminai

Page 2 - Mounting Bracket Installation

Choose a mounting method: chain, cable, rod or surface mount.Chain Cable Rod SurfaceHang up to two chains, cables or rods from a structural member of

Page 3 - Surface Mount Installation

Option B: Attach directly to junction boxSurface Mount InstallationOption A: Attach using mounting holes113 422Loosen screws on side of xture and unh

Page 4 - Electrical Connections

3 4Option: power input from side – Remove knockout in endcap and A) Install 1/2” conduit, or B) install AC power cord with strain relief. Plug unused

Page 5 - Continuous Run Installation

When ordered as an option, continuous run xtures use quick-connectors and keyhole fasteners to properly wire & align the joining xtures.5 67Shif

Page 6 - Troubleshooting

Control Module Wiring SchemeEach 14” wireless control / occupancy sensor module will power up to 48 ft. of xtures (maximum 24 ft. per side). Note: Th