Ge ZGU484NGPSS User Manual download pdf (Page 13)

TOOLS AND MATERIALS REQUIRED

• Gloves to protect against sharp edges

• T-15 and #2 Phillips screwdrivers

• Drill with 3/32” and 9/64” bits

• Safety glasses

• Level

• Pencil

This Kit Includes

• Top wall support

• Bottom wall support

• Top cover with shelf

• Bottom cover

• Hardware package with

– 9 Stainless Steel Torx 15 #8

self-tapping screws

– 9 Phillips #2 pan head wood #10 screws

– 3 Stainless Steel #2 truss head

#10 screws (for alternate

installation method)

WARNING:

To prevent ignition of combustible materials,

the entire back wall above the range must be

protected by a backsplash constructed of non-

combustible material.

$&&(6625,(6³” TO 36” ADJUSTABLE BACKSPLASH (not included)

ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessory Installation

INSTALL THE WALL SUPPORT PANELS

ARNING:

The wall support panels

must be securely fastened to the wall. Failure to

do so could result in damage or personal injury.

IMPORTANT: This backsplash is designed to cover the wall

between the bottom of the hood and the top of the range.

The vent hood should be installed over the rangetop or

range before installing this backsplash.

• Install and level the Range/Rangetop according to the

product installation instructions.

• Remove backsplash packaging and protective film.

• Locate wall studs on each side. Where studs are not

available, plan to use wall anchors (not provided).

• Use a level to pencil 2 horizontal lines on the wall, one

1/8” below the vent hood and the other 1/8” above the

Range/Rangetop. This 1/8” space allows the cover panels

to overlap the wall supports.

• Secure the top wall support panel to the wall with 4 wood

screws, through the outermost studs.

• Use 4 wood screws to secure the bottom wall support

panel. The center slot should be positioned at the top.

The gap between the top and bottom support panels will be

covered by the top cover with shelf.

1/8”

Secure the

top panel to

the wall with 4

wood screws

1/8”

Secure the

bottom panel

to the wall

with 4 wood

screws

Center

Arrow

Wood Screws

Wood

Screws

Top Wall

Support

Top Cover

with Shelf

Bottom Cover

Bottom Wall Support

Hardware

Package

BEFORE YOU BEGIN

Read these instructions completely

and carefully.

IMPORTANT: Save these instructions for local

inspector’s use.

IMPORTANT: OBSERVE ALL GOVERNING CODES AND

ORDINANCES.

NOTE TO INSTALLER: Be sure to leave these

instructions with the Consumer.

NOTE TO CONSUMER: Keep these instructions with

your Owner’s Manual for future reference.

• This backsplash adjusts to fit the space between

the top of the range and the bottom of the hood,

from 30” Min. to 36” Max. height.

• Maximum shelf load-bearing weight is 40 lbs.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Comments to this Manuals

No comments

Ge ZGU484NGPSS User Manual Page 13

Comments to this Manuals

Related products and manuals for Stoves Ge ZGU484NGPSS