Ge PHP960DMBB User Manual download pdf (Page 4)

Installation Instructions

PREPARING THE OPENING

Ш The following MINIMUM clearance dimensions

must be maintained.

13" MAX. Depth

of uprotected

overhead

cabinets

2" MIN. Clearance

from cutout to

side wall on the

right of the unit

15" MIN. Height

from countertop to

nearest cabinet on

either side of unit

2" MIN. Clearance from

cutout to side wall on the

left of the unit

If a 30" clearance between the cooking surface and

overhead combustible materials or metal cabinets

cannot be maintained, a minimum clearance of 24"

is required and the underside of the cabinets above

the cooktop must be protected with not less than

1/4" insulating millboard covered with sheet metal

not less than 0.0122" thick.

H OVERALL COOKTOP DIMENSIONS

20-7/8"

(21" SS) at center

4-5/8" at front

- ^ baffle

3-1/4" at rear air

intake

18-7/8'

H VERTICAL CLEARANCES

Allow 12" minimum vertical

clearance from the cooktop i4-i/4-

bottom (or 14-1/4" minimum

depth from the countertop) to

any combustible surfaces, such

as a cabinet drawer.

IMPORTANT: To ensure long life

of the electronic components,

allow a minimum of 12" free

space for air circulation below

the cooktop bottom. (Except

installation over a single oven.)

The cooktop bottom has air

intake ports and exhaust ports

that help cool the components.

Do not install a shelf or partition

beneath the cooktop that is |

more than 18" deep. ^

12"

DRAWER

14-1/4"

12"

---------

18" Max. I

Deep Shelf

H CUTOUT DIMENSIONS OF THE

COUNTERTOP

To insure accuracy, it is best to make a template

when cutting the opening in the counter.

19-1/8" depth of cutout

1-3/4" Min. Between

cutout and the wall

behind the cooktop

2-1/2" Min. from

front edge of cutout

and front edge of

countertop

Use a 36" or wider cabinet base.

Make sure the wall coverings, countertop and

cabinets around the cooktop can withstand

heat (up to 200°F) generated by the cooktop.

Wall coverings,

cabinets and

countertop must

withstand heat

up to 200°F.

H FOR AMERICANS WITH DISABILITIES

ACT (ADA) FORWARD APPROACH

INSTALLATION ONLY:

NOTE: The enclosure must be made of wood

material. Also, an access panel is required for the

junction box, hold-down brackets, and service.

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

Ge PHP960DMBB User Manual Page 4

Comments to this Manuals