GE JDS26 User Manual download pdf (Page 31)

QUESTIONS?

USE THIS PROBLEM SOLVER

PROBLEM POSSIBLE CAUSE

“F–AND A NUMBER • This is a function error code. Press CLEAR/OFF. Allow the oven to cool one

OR LETTER” FLASH hour. Place the oven back into operation.

IN THE DISPLAY

• Disconnect all power to the oven for 5 minutes and then reconnect power.

If the failure code repeats, call for service.

DISPLAY GOES BLANK • The circuit breaker in your house has been tripped, or a fuse has been blown.

DISPLAY FLASHES • Power failure. Reset the clock.

UNABLE TO GET THE • BAKE and BROIL HI/LO must be pressed at the same time and held for

DISPLAY TO SHOW “SF” 2 seconds.

CONTROL SIGNALS AFTER • This is reminding you to press BAKE and then enter a temperature.

ENTERING COOKING TIME

• This is reminding you to enter a bake temperature after having

OR DELAY START TIME

pressed BAKE.

CLOCK AND TIMER • Make sure the electrical plug is plugged into a live, properly grounded

DO NOT WORK power outlet.

• Check for power outage.

• See the Oven Control, Clock and Timer section.

SURFACE UNITS NOT • Surface units are not plugged in solidly.

FUNCTIONING PROPERLY

• Surface unit controls are not properly set.

OVEN WILL NOT WORK • The plug on the range is not completely inserted in the electrical outlet.

• The circuit breaker in your house has been tripped, or a fuse has been blown.

• The oven controls are not properly set.

FOOD DOES NOT • Oven controls not set properly. See the Broiling section.

BROIL PROPERLY

• Door not left open to the broil stop position as recommended.

• Improper shelf position being used. See the Broiling Guide.

• Food is being cooked on a hot pan.

• Cookware is not suited for broiling.

• Low voltage. See the Broiling section.

• Aluminum foil used on the broiler pan and grid has not been fitted properly

and slit as recommended.

(continued next page)

Care and Cleaning Problem Solver

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

No comments

GE JDS26 User Manual Page 31