GE 45130 User Manual download pdf (Page 8)

Follow these steps to assign a Sensor to a Zone.

Step 1 – Press and hold the Learn button on the

Control Center for three seconds. When the

Control Center sounds a long beep, release the

Learn button.

Step 2 – Press the Zone button (1, 2, 3 or 4) for the

Zone you want to assign to the Garage Door Sensor.

The LED indicator for that Zone will begin to ﬂash.

Step 3 –

Release the Zone button.

Note: Zone 4 is for dedicated alerts only. Sensors in this Zone

will not trigger an alarm or chime.

Step 4 – Activate the Garage Door Sensor

To activate The Garage Door Sensor, lower

the detection rod to its full extension; if mounted,

raise the garage door.

Erasing the Sensor from a Zone

Note: If you need to remove the Sensor from a Zone, the

system will erase the entire Zone, so any other Sensors will

need to be put back into that particular Zone.

Step 1 - To erase a Zone, press and hold the

1 2 3 4

Arm

Zone

Armed Power

1 2 3 4

Alert

Chime

Off

Mute

Learn

Input DC 12V

Add a Sensor

Step 1

Press and hold

the Learn button

for three seconds

Step 3

Release the

Zone button

Step 4

Activate the Garage

Door Sensor

Step 2

Select the Zone number

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

GE 45130 User Manual Page 8

Comments to this Manuals

Related products and manuals for Security device components GE 45130