GE GX1S50R Instruction Manual download pdf (Page 7)

Installation Instructions

INSTALL THE FAUCET (CONT.)

6. Feed the water tube up through the faucet base.

Then push the tube into the fitting on the bottom

of the faucet body. It should go in about 3/4″.

Pull tube slightly to make sure it is secure.

7. Push the faucet body down into the faucet base

and twist clockwise until it clicks into place.

NOTE: You can install the faucet so the handle

is on the right or the left side.

If you want the faucet handle on the right,

position the handle at the back of the faucet

base before turning clockwise.

If you want the faucet handle on the left,

position the handle at the front of the faucet

base before turning clockwise.

8. Locate the hole at the rear of the base. Insert

set screw and begin to tighten by hand. Finish

tightening with the Allen wrench provided

in the packet.

Faucet Body

Base

Sink

Gasket

Toggle Screw

Faucet Faucet

Faucet handle on the RIGHT Faucet handle on the LEFT

MOUNTING SYSTEM INSTALLATION

Pick a location under the sink to mount the system.

Location should be easily accessible, with at least 5

inches of clearance between the bottom of the filter

canister and the floor or bottom of the cabinet; any

less will result in difficulty of removing filter canister.

Allow enough space on either side of the system for

the tubing connections.

A. PREFERRED INSTALLATION

(Mounting Using the Screw Provided [Fig. 4])

1. Remove shrink wrap from filter system.

2. System should be mounted to a stud in the wall

or solid firm surface.

3. Use the screw (B) provided to mount through the

screw hole in the center of the manifold (A). (Pre-drill

a 1/16″ pilot hole, if needed). NOTE: If mounting to

drywall, with no stud, a drywall anchor (not

included) must be used.

B. OPTIONAL INSTALLATION

(Mounting Using the Mounting Tape Provided [Fig. 5])

(If mounting to drywall, the screw must be used also).

1. Remove shrink wrap from filter system.

2. Clean wall surface to remove any dirt, oil or grease

and dry thoroughly.

Using the double-sided mounting tape provided (C),

remove one side of the protective wax paper and

apply the entire piece to the back side of the

manifold (A), applying firm pressure to the entire

piece.

4. Remove the remaining wax paper from the

double-sided mounting tape (C) and adhere it to

the cleaned wall surface, applying firm pressure

to the entire piece.

Fig. 4

(B) Screw

(A) Manifold

Fig. 5

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

GE GX1S50R Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Sanitary ware GE GX1S50R