GE PNM9196SFSS Instruction Manual download pdf (Page 8)

Find the studs, using one of the following methods:

A. Stud finder – a magnetic device which locates nails.

B. Use a hammer to tap lightly across the mounting

surface to find a solid sound. This will indicate

a stud location.

After locating the stud(s), find the center by probing

the wall with a small nail to find the edges of the stud.

Then place a mark halfway between the edges.

The center of any adjacent studs should be 16s or 24s

from this mark.

Draw a line down the center of the studs.

IMPORTANT: The microwave must be connected to at

least one wall stud.

Remove the box containing the installation

instructions, filters, exhaust adaptor, damper

and the small hardware bag. Do not remove

the foam packing protecting the front of the oven.

Fold back all 4 carton flaps fully against carton sides.

Then carefully roll the oven and carton over onto

the top side. The oven should be resting in the foam

packing.

REMOVING THE OVEN FROM

7+(&$57215(029,1*

THE MOUNTING PLATE

),1',1*7+(:$//678'6

PLACEMENT OF THE MOUNTING PLATE

Wall

Studs

Center

Carton

Pull the carton up and off the oven.

Open the oven door and remove the foam pack

from inside the oven. Remove the tape covering the

turntable hub.

Foam

packing

Installation Instructions

Set the oven upright. Remove and properly discard

plastic bags and foam packing.

The mounting plate is attached to the back of the

oven. Remove the two screws holding it to the oven.

The plate will be used as the rear wall template and

for mounting the oven to the wall.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comments to this Manuals

No comments

GE PNM9196SFSS Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Microwaves GE PNM9196SFSS