GE PNM9196SFSS Instruction Manual download pdf (Page 17)

Snip all 4 webs

on each knockout

panel and

remove the metal

knockouts for rear

airflow.

Locate the two “knockout” plates, on the rear oven

panel, near the top of the oven.

Using tin snips, carefully cut the web area from the

two holes side-by-side (that secure the knockouts to

the oven). Cut all four webs on both rear knockouts;

this will allow the ventilation fan airflow to exhaust

out the rear of the oven.

CAUTION: Be sure to trim the sharp

HGJHVIURPWKHRSHQLQJVDIWHUUHPRYLQJWKH

NQRFNRXWSODWHV

AFTER: Fan Blade

2SHQLQJV)DFLQJ

%DFN

Place the blower unit back into the opening.

Roll the blower unit 90° so that fan blade openings

are facing out the back of the oven.

Blower Plate

Before Rolling

After Rolling

Back of

Oven

End A

End B

Back of

Oven

Back of

Oven

WARNING:5LVNRIHOHFWULFVKRFN

can cause injury or death. Do not pull or stretch

WKHEORZHUXQLWZLULQJPDNHVXUHWKHZLUHVDUH

not pinched..

NOTE: The blower unit exhaust openings should

match exhaust openings on rear of microwave.

Installation Instructions

2YHQ5HDU3DQHO

Attach the exhaust adaptor to the rear of the oven

by sliding it into the guides at the top center of the

back of the oven.

Close the blower plate so it is closed over the top

tab of the exhaust adapter. Secure with the screw

removed earlier.

Push down securely until it is in the lower locking

tabs. Take care to assure the damper hinge

is installed so that it is at the top and that the

damper swings freely.

Slide

exhaust

adaptor into

guides on

oven rear.

Exhaust Adaptor

Damper

(hinge side up)

Locking

Tabs

Guides

Back of

Oven

Screw

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Comments to this Manuals

No comments

GE PNM9196SFSS Instruction Manual Page 17

Comments to this Manuals

Related products and manuals for Microwaves GE PNM9196SFSS