GE PNM9196SFSS Instruction Manual download pdf (Page 13)

MOUNT THE OVEN

$66(0%/($1',167$//$'$3725

86(723&$%,1(77(03/$7()25

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws,

a hole large enough for the power cord to fit through,

and a cutout large enough for the exhaust adaptor.

Damper

Front of

Oven

Back of Oven

Remove Screw from

Back of Blower Plate

Remove Screw from

Top of Blower Plate

 Read the instructions on the TOP CABINET TEMPLATE.

 Tape it underneath the top cabinet.

 Drill the holes, following the instructions on the TOP

CABINET TEMPLATE.

CAUTION::HDUVDIHW\JRJJOHVZKHQ

GULOOLQJKROHVLQWKHFDELQHWERWWRP

Installation Instructions

Place the oven in its upright position, with the top

of the unit facing up and the front of the unit facing

toward you.

Remove the screw on the back side of the blower

plate and raise the blower plate off of the microwave.

Slide the damper from left to right into the tabs on the

blower plate. The yellow tape on the damper should

be facing you. If the blower plate is not raised off of

the top of the microwave, the damper cannot slide

into position.

Remove the yellow tape from the damper. 0DNHVXUH

WKDWWKHGDPSHUSLYRWVHDVLO\EHIRUHPRXQWLQJRYHQ

You will need to make adjustments to assure proper

alignment with your house exhaust duct after the

oven is installed.

Exhaust

Adaptor

Blower Plate

Tabs

CAUTION: 7RDYRLGWKHULVNRISHUVRQDO

LQMXU\EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH

ZHLJKWRIWKHPLFURZDYHRUSURSHUW\GDPDJH\RX

ZLOOQHHGWZRSHRSOHWRLQVWDOOWKLVPLFURZDYH

IMPORTANT: Do not grip or use handle during

installation.

WARNING: 5LVNRI(OHFWULF6KRFN

&DQFDXVHLQMXU\RUGHDWK,ILQVWDOOLQJXQLW

ZLWKPHWDOFRXQWHUWRSVFRYHUWKHHGJHRIWKH

power supply cord hole with the power supply cord

EXVKLQJ

IMPORTANT: If filler blocks are not used, case damage

may occur from overtightening screws.

Insert a self-aligning screw through top-center

cabinet hole. Temporarily secure the oven by

turning the screw at least two full turns after

the threads have engaged. (It will be completely

tightened later.)

NOTE: When mounting

the microwave, thread

power cord through hole

in bottom of top cabinet.

Keep it tight throughout

Steps 1–3. Do not pinch

cord or lift oven by pulling

cord.

Lift microwave, tilt it

forward, and hook slots

at back bottom edge

onto four lower tabs of

mounting plate.

Rotate front of oven up

against cabinet bottom.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Comments to this Manuals

No comments

GE PNM9196SFSS Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Microwaves GE PNM9196SFSS