GE 20338 Instruction Manual download pdf (Page 9)

9

Fan Installation

HANGING THE FAN

WARNING: failure to properly install

cotter pin as noted in step 5 could

result in fan loosening and possibly

falling.

1. Remove the clevis pin (CC),

cotter pin (DD) and collar set

screws (BB) from the top of the

fan motor assembly (V).

2. Route wires exiting from the

top of the fan motor through the

coupling cover (U), canopy cover

(S), canopy (R) and then through

the ball / downrod assembly (T).

NOTE: if a longer downrod (not

included) is needed, take out

the screw located in the hanger

ball, lower the hanger ball and

remove the pin. Remove all

3 pieces from the downrod

and assemble them into the

new longer downrod before

proceeding to step 2.

3. Align the holes at the bottom

of the downrod (T) with the holes

in the collar on top of the fan

motor assembly (V). Carefully

insert the clevis pin (CC) through

the holes in the collar and

downrod (T). Be careful not to

jam the clevis pin (CC) against

the wiring inside the downrod (T).

5. Tighten two set screws (BB)

at top of the fan motor collar

ﬁrmly and evenly until fully

engaged. Once set screws

have been installed, tighten

each nut (located on set screws)

completely against motor collar.

4. Insert the cotter pin (DD)

through the hole near the end of

the clevis pin (CC) until it snaps

into its locked position.

CC

V

DD

BB

T

R

S

U

T

CC

DD

BB

V

CC

DD

BB

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Comments to this Manuals

No comments