Ge JGP337 User Manual download pdf (Page 14)

30″ Sealed Gas Cooktop

Installation Instructions

CAUTION: Before you begin—read these

instructions completely and carefully.

• IMPORTANT—Save these instructions for

local inspector’s use.

• IMPORTANT—OBSERVE ALL GOVERNING

CODES AND ORDINANCES.

• Note to Installer—Be sure to leave these

instructions with the Consumer.

• Note to Consumer—Keep these instructions

and conversion kit for future use.

•Note—This appliance must be properly

grounded.

• IMPORTANT: Leak testing of the appliance

shall be conducted according to the

manufacturer’s instructions.

• Skill level—Installation of this appliance

requires basic mechanical skills.

• Proper installation is the responsibility of

the installer.

• Product failure due to improper installation

is not covered under the Warranty.

PARTS INCLUDED

Joint Sealant

Pipe Fittings

MATERIALS YOU MAY NEED

Shut Off

Valves

In the Commonwealth of Massachusetts:

• This product must be installed by a

licensed plumber or gas fitter.

• When using ball-type gas shut-off valves,

they shall be the T-handle type.

• A flexible gas connector, when used,

must not exceed 3 feet.

2 Screws

Regulator

2 Hold Down

Brackets

Foam Tape

If you have questions, call 1.800.GE.CARES or visit our Website at: www.GEAppliances.com

CONVERSION KIT

4 LP/

Propane

Orifices

Conversion

Label

Conversion LabelConversion LabelConversion LabelConversion LabelConversion LabelConversion Label

LP to Natural Gas ConversionLP to Natural Gas ConversionLP to Natural Gas ConversionLP to Natural Gas Conversion

For All GE Gas CooktopsFor All GE Gas CooktopsFor All GE Gas CooktopsFor All GE Gas CooktopsFor All GE Gas Cooktops

For All GE Gas CooktopsFor All GE Gas CooktopsFor All GE Gas CooktopsFor All GE Gas CooktopsFor All GE Gas

LP to Natural Gas ConversionLP to Natural Gas ConversionLP to Natural Gas ConversionLP to Natural Gas Conversion

----------------------------------

This cooktop is designed to operate on natural

gas at 4 of water column pressure. It is

shipped from the factory set for natural gas.

The convertible pressure regulator supplied

with the unit must be connected in series with

the manifold of the cooktop and must remain

in series with the supply line regardless of

whether natural or L.P . gas is being used.

FOR PROPER OPERATION, THE MAXIMUM

INLET PRESSURE TO THE REGULATOR

MUST BE NO MORE THAN 14 OF WATER

COLUMN PRESSURE. For checking the

regulator , the inlet pressure must be at least

1 (or 3.4 KP A) greater than the regulator

output setting. If the regulator is set for 4 of

water column pressure, the inlet pressure

must be at least 5 . If the regulator is set for

10 , the inlet pressure must be at least 1 1.

The gas supply line to the cooktop should be

1/2 or 3/4 pipe.

---------------------------------------

------------

-----------------------------------

WARNING: Never reuse old flexible

connectors. The use of old flexible

connectors can cause gas leaks and

personal injury. Always use new

flexible connectors when installing

a gas appliance.

Screw a section of pipe

onto each end of the

pressure regulator.

-------------------------------------

--------------------------------------

Pressure

Regulator

Shut Off

Valve

Electrical

Outlet

12" Below

Countertop

Screw the

regulator and

pipe connection

into the burner

box bottom.

Make sure the

top of the

regulator is

facing toward

the cabinet front,

easily accessible

through the

cabinet doors.

---------------------------------------------------------

----------------------------------------------------------

To reduce the likelihood of gas leaks, apply

teflon tape or a thread compound approved

for use with LP or natural gases to all

threaded connections.

Pressure

Regulator

-------------------------------------------

-------------------------------------

----------------------------------------

--------------------------------

Shut Off

Valve

Electrical

Outlet

12" Below

Countertop

Install a manual shutof

f valve in the gas line

in an easily accessible location outside the

cooktop. Be sure you know how and where to

shut of

f the gas supply to the cooktop. Install

the electrical outlet 12

below the countertop.

-------------------------

---------------------------

-------------------------

------------------

Conversion

Instructions

1/8″ Drill Bit &

Electric or

Hand Drill

Phillips Head Screwdriver

Pencil

Ruler or

Straightedge

Saber Saw

TOOLS YOU WILL NEED

Pipe Wrench

Flat-Blade Screwdriver

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Comments to this Manuals

No comments

Ge JGP337 User Manual Page 14

Comments to this Manuals

Related products and manuals for Hobs Ge JGP337