GE GAS18PGJWW Installation Manual download pdf (Page 5)

About storage drawer and cover removal. GEAppliances.com

Not all features are on all models.

Cover Removal

To remove:

Remove the drawers.

Reach in, push the back of glass cover up,

and at the same time, pull it backward as

far as it will come.

Tilt it and take it out. Avoid cleaning the cold

glass cover with hot water because the extreme

WHPSHUDWXUHGLȺHUHQFHPD\FDXVHLWWREUHDN

Remove the drawer frame. (Always remove

the glass cover before you take out the

drawer frame.)

/LIWWKHIUDPHRȺWKHVXSSRUWVDWHDFKVLGHDQG

back, pull it forward, tilt it and take it out.

To replace:

Lower the frame until it rests on the

supports at each side and back.

Replace the glass cover, pushing its front

HGJH¿UPO\LQWRWKHIURQWIUDPHFKDQQHO

and gently lowering the back into place.

Replace the drawers.

Drawer Removal

Drawers can be removed easily by grasping

the sides and lifting up slightly while pulling

drawers past the stop location.

Humidity Controlled Drawer (on some models)

Slide the control all the way to the

HIGH setting to provide high humidity

recommended for most vegetables.

Slide the control all the way to the LOW

setting to provide lower humidity levels

recommended for most fruits.

CAUTION

Avoid contact with the

moving parts of the ejector mechanism, or

with the heating element (located on the

bottom of the ice maker) that releases the

FXEHV'RQRWSODFH¿QJHUVRUKDQGVRQWKH

automatic ice making mechanism while the

refrigerator is plugged in.

Automatic Ice maker (on some models).

The ice maker will produce approximately

70-100 cubes in a 24-hour period, depending

on the freezer compartment temperature, room

temperature, number of door openings and other

use conditions.

If the refrigerator is operated before the water

connection is made to the ice maker, set the

switch OFF.

When the refrigerator has been connected to the

water supply, set the switch ON position.

7KHLFHPDNHUZLOO¿OOZLWKZDWHUZKHQLWFRROVWR

15°F. A newly-installed refrigerator may take 12 to

24 hours to begin making ice cubes.

Once the ice maker starts to make ice, it may take

XSWRKRXUVWR¿OOWKHELQGHSHQGLQJRQWKH

temperature settings and number of door openings.

You will hear a buzzing sound each time the ice

PDNHU¿OOVZLWKZDWHU

NOTICE:

7KURZDZD\WKH¿UVWIHZEDWFKHVRILFH

to allow the water line to clear.

Be sure nothing interferes with the sweep of the

feeler arm.

:KHQWKHELQ¿OOVWRWKHOHYHORIWKHIHHOHUDUPWKH

ice maker will stop producing ice.

It is normal for several cubes to be joined

together.

If ice is not used frequently, old ice cubes will

become cloudy, taste stale, shrink or fuse together.

Ice maker accessory kit:

If your refrigerator did not already come equipped

with an automatic ice maker, an ice maker

accessory kit is available at extra cost.

&KHFNWKHEDFNRIWKHUHIULJHUDWRUIRUWKHVSHFL¿F

ice maker kit needed for your mode

About the automatic ice maker

A newly-installed refrigerator may take 12–24 hours to begin making ice.

OFF

Ice maker

Feeler Arm

Power Switch

1 2 3 4 5 6 7 8 9 10 ... 59 60

Comments to this Manuals

No comments

GE GAS18PGJWW Installation Manual Page 5

Comments to this Manuals

Related products and manuals for Fridges GE GAS18PGJWW