GE PJ7000SFSS Use and Care Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
13
When installed, the front face of the warming drawer
will be nearly flush with cabinetry doors or drawer
fronts.
Drawer overlaps will conceal cut edges on all sides of
the opening.
The rough opening for the drawer must be:
³'HSWK 23
1
ø2” minimum from inside back to front of
cabinet frame.
³:LGWK 25
1
ø2” for 27" wide models
28
1
ø2” for 30" wide models.
³+HLJKW 9
1
ø4
³$OORZPLQLPXPEHWZHHQRYHQDQGGUDZHUFXWRXWV
for clearance of overlaps.
NOTE: If you are installing in frameless cabinets, it may
be necessary to install 1/2" wide cleats to accept drawer
mounting screws. See drawer to find exact locations of
mounting screws.
When installed under a wall oven:
Warming drawers are suitable for installation below
only certain specified wall oven models. See the label
attached to the top of the warming drawer for suitable
models.
NOTE: Electrical receptacle can be installed as shown for
countertop installations. Do not install receptacle above
the top of the warming drawer cutout.
23
1
ø2
Min.
2x2 or 2x4
anti-tip block
against rear
wall 9” from
floor to bottom
of block
1" Min. above toekick or
adjust to oven installation
height
A
NOTE: Additional clearance between cutouts
may be required. Check to be sure that oven
supports above the warming drawer location
do not obstruct the required interior 23
1
ø2
depth and 9
1
ø4” height.
Installation below a single oven
NOTE: Additional clearance between cutouts
may be required. Check to be sure that oven
supports above the warming drawer location
do not obstruct the required interior 23
1
ø2
depth and 9
1
ø4” height.
Installation below a double oven
2" Min.
Allow 5/8”
overlap on
all sides
10
1
ø2
23
1
ø4
Installation Below Wall Ovens
GEAppliances.com
Read these instructions completely and carefully.
9"
9
1
ø4
B
Oven
cutout
2" Min
1" Min. above
toekick
2x2 or 2x4 anti-
tip block against
rear wall 9” from
floor to bottom
of block
23
1
ø2
Min.
Allow 5/8” overlap
on all sides
A
23
1
ø4
10
1
ø2
9"
9
1
ø4
Oven
cutout
B
IN CANADA, THIS DRAWER IS NOT APPROVED
FOR INSTALLATION UNDER A DOUBLE OVEN.
Dimension A Dimension B
27 " Drawer 25
1
ø2 26
3
ø4
30 " Drawer 28
1
ø2 29
3
ø4"
IN CANADA, THE WALL
OVEN IS ONLY APPROVED
FOR INSTALLATION WITH
A BOTTOM CUTOUT AT A
MINIMUM OF 32.5” FROM
THE FLOOR.
CAUTION
CAUTION
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments