Ge DCXH46 User Manual download pdf (Page 19)

WARNING:

• To reduce the risk of electric shock, disconnect this

appliance from the power supply before attempting

any user maintenance. Turning the controls to the

OFF position does not disconnect this appliance

from the power supply.

• Refer to the washer and dryer installation instructions

prior to stacking appliances. Reading all of the

information contained in these instructions will simplify

the installation and ensure a correct and safe operation.

A fire hazard and/or personal injury could result from

improper installation.

Stacking Instructions

TOOLS REQUIRED FOR STACKING

THE DRYER

• Phillips head screwdriver

• Channel-lock adjustable pliers

MOUNTING THE DRYER TO

THE WASHER

The numbers in the illustration correspond to steps.

1. Remove the washer top panel by first removing the 4

screws in the 2 brackets located on the top rear of the

washer.

Slide the top forward, lift the front of the top up and

remove the top panel.

Remove the 2 brackets from the rear of the top panel.

2. Using the 4 screws that were removed in step 1, install

the brackets in the rear support as shown.

3. Remove the 4 screws and the 2 long front brackets

located on the top front of the washer.

4. Install the 2 new front mounting brackets provided and

the 4 screws that were removed in step 3. Note that the

tab of the front mounting bracket is facing forward as

shown in the illustration.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

No comments

Ge DCXH46 User Manual Page 19