Ge PDT750SSFSS User Manual download pdf (Page 7)

STEP 8: INSTALL DRAIN HOSE TO DRAIN

LOOP

Connect drain loop end to drain hose using the screw clamp

as shown in the figure.

STEP 7: INSTALL 90° ELBOW

• Thread 90° elbow

onto the water valve.

• Do not overtighten

elbow. Water valve

bracket could

bend or water valve

fitting could break.

• Position the end of

the elbow to face the

rear of the dishwasher.

STEP 6: REMOVE FLOOR PROTECT

• Disconnect leak sensor wire

(on some models).

• Remove 2 screws from front of the

Floor Protect with a ¼” driver.

• Rotate Floor Protect outward and lift

out of the mounting tabs.

• Set aside for use in Step 22.

Dishwasher Installation

Figure N

Power Cord

(If Used)

Insulation

Blanket

Water

Line

Maximum Drain Hose

Length 15'

House

Wiring

Drain

Hose

Figure P

STEP 10:

INSTALL DRAIN HOSE,

THROUGH CABINET

• Position dishwasher in front of cabinet opening. Insert drain

hose into the hole in cabinet side. If a power cord is used,

guide the end through a separate hole.

STEP 9: POSITION WATER LINE

AND HOUSE WIRING

• Position water supply line and house wiring on the floor of

the opening to avoid interference with base of dishwasher

and components under dishwasher.

Figure O

Water

Line

House

Wiring

7LS3UHYHQWXQQHFHVVDU\VHUYLFHFDOOFKDUJHVIRU¿OOGUDLQ

or noise concerns.

Position utility lines so they do not interfere with anything

under or behind the dishwasher.

Figure M

Water Valve

Bracket

90° Elbow

Fill Hose

Front of dishwasher

NOTE: The high drain loop on the side of the tub is designed for

better wash performance. Do not remove from the side of the tub.

Floor Protect

Leak Sensor

Figure L

Squeeze connector at top

to release snap feature

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Comments to this Manuals

No comments

Ge PDT750SSFSS User Manual Page 7

Comments to this Manuals

Related products and manuals for Dishwashers Ge PDT750SSFSS