GE JP202 User Manual download pdf (Page 13)

Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support

Installation of the cooktop. ge.com

Read these instructions completely and carefully.

Installation Instruction

✻

Max. distance of 7″ when installing over GSM2100 dishwasher

Suggested mounting of an approved junction box.

Before installing the counter unit or moving it to

another location have the electrician verify:

■ That your home is provided with adequate

electrical service.

■ That the addition of the counter unit will not

overload the household circuit on which it is

used.

DANGER: Always disconnect the

electrical service to the unit before repairing or

servicing the counter unit. This can be done by

disconnecting the fuse or circuit breaker. Failure

to do this could result in a dangerous or even

fatal shock. Know where your main disconnect

switch is located. If you don’t know, have your

electrician show you.

Install an approved junction box where it will be

easily accessible through the front of the cabinet

where the counter unit will be located.

IMPORTANT: The junction box must be located

where it will allow slack in the conduit for

serviceability. If installing over a GSM2100

dishwasher, the center of the junction box must

be installed 5 ″ to 7 ″ below the cooktop lip,

so it does not interfere with the dishwasher

installation or operation.

Install the counter unit in the cutout opening.

NOTE: If the unit is being installed in a blind counter

(one with no cabinet opening below) or over a GSM2100

dishwasher, wire connections must be made before putting

the unit into the cutout.

Secure the cooktop unit to the counter using the

side retainers and screws shipped with the unit.

■ For thicker counters (greater than 1″ thick),

hold down straps should be used to install

the cooktop. They are included with some

models, or can be ordered, GE model

number WB2K5328.

■ To attach the cooktop to the counter, insert

the hold-down strap into the slots on each side

of the unit (see diagram).

■ Use suitable screws to attach the cooktop to

the counter as shown. The cooktop must rest

on the metal flange around the burner box.

Be sure this cut does not interfere with the cabinet structure at the front

5″ Min.

✻

5″ Min.

✻

Hold down retainer

Allow considerable slack

for serviceability

Self tapping screw

Mounting slot

Cabinet sides

Burner box sides

Use suitable

fasteners for

anchoring in

cabinet sides

Strap

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

GE JP202 User Manual Page 13

Comments to this Manuals