49-8521906-14 GEInstallation Instructions36”Rangetop
10InstallationINSTALL RANGETOP• Slide the rangetop into the opening. Make sure the rangetop is evenly seated and supported. • A hold-down strap with s
11InstallationCONNECT ELECTRICAL• Plug power cord into properly grounded receptacle.• Press the button on the left side of the control panel. The li
12ZX12B30PSS, ZX12B36PSS, ZX12B48PSS Accessory Installation237,21$/$&&(6625,(6³” HIGH BACKSPLASHTOOLS AND MATERIALS REQUIRED • Gloves to pr
13TOOLS AND MATERIALS REQUIRED • Gloves to protect against sharp edges• T-15 and #2 Phillips screwdrivers• Drill with 3/32” and 9/64” bits• Safety gl
14INSTALL COVER PANELS (cont.)ALTERNATE METHOD: When side access is blocked• Install bottom cover over the bottom support while driving one screw in
15TOOLS YOU NEEDED FOR CONVERSION2 CONVERT THE REGULATORDisconnect all electrical power at the main circuit breaker or fuse box. A. Remove the re
164 ** CHANGE GRILL ORIFICE (cont.) A. Remove the grill cover, grates and grate frame. Lift the radiant baffle straight up and off. B. Remove t
175 CHANGE GRIDDLE ORIFICE (if present)Locate the 3/4” long griddle orifice. Select for your gas type. LP³.047, NAT³.076 A. Lift off the griddle fl
18Notes
19Notes
2Safety InformationBEFORE YOU BEGIN Read these instructions completely and carefully.• IMPORTANT³ Save these instructions for local inspector’s use.
CONTENTSDesign InformationModels Available ...3Backsplash Accessories ...
4PRODUCT DIMENSIONS AND CLEARANCES FOR 48” MODELSDesign Information27-1/2” to Front of Bullnose8-1/2” Height22-3/4” Min.2-1/2”8”7/8”Universal Utility
PRODUCT DIMENSIONS AND CLEARANCES FOR 36” MODELSDesign Information35-7/8” Width 8-1/2” Height5Universal Utility Locations2”17”16”Locate gas inlet on b
***8” Countertop Level6Design InformationCooktop1/2” Above AdjacentCountertops.Cooktop1/2” Above AdjacentCountertops.Rangetop1/2” Above Adjacent Count
POWER SUPPLY LOCATIONSGas Supply: • The natural gas models are designed to operate at 5” water column pressure. For proper operation, the pressure o
8Installation PreparationREMOVE PACKAGING• Cut the ties holding the grill grate to the grill frame.• Lift off burner caps and remove foam pad, then l
Dimensions A (Dia.) B C D 36” Rangetop 7-3/8” 1-1/2” 7-1/2” 11-1/8” 48” Rangetop 8-1/4” 1-1/2” 7-1/2” 11-1/8”Measure carefully when cutting the
Comments to this Manuals