Ge AJCQ08ACF User Manual download pdf (Page 7)

GEAppliances.com

COOL MODE

Remote Control

1. Press COOL pad.

2. Press LOW or HIGH pads to set desired fan speed.

3. Press the ,1&5($6('(&5($6(²pads to set the desired

temperature 60°F to 85°F in 1°F increments.

Control Panel

1. Press the MODE pad until the COOL indicator light is lit.

2. Press the FAN pad until HIGH or LOW indicator light

is lit for desired fan speed.

3. Press the,1&5($6('(&5($6(²pads to set the desired

temperature 60°F to 85°F in 1°F increments.

A thermostat is used to maintain the room temperature. The

compressor will cycle on and off to keep the room

at the set level of comfort. Set the thermostat at a lower

number and the indoor air will become cooler.

Set the thermostat at a higher number and the indoor air will

become warmer.

NOTE: If the air conditioner is off and is then turned on while set

to COOL, it will take approximately 3 minutes

for the compressor to start and cooling to begin.

Cooling Descriptions

)RU1RUPDO&RROLQJ³Select the COOL mode and HIGH fan

with a middle set temperature.

)RU0D[LPXP&RROLQJ³Select the COOL mode

and HIGH fan with a lower set temperature.

)RU4XLHWHUDQG1LJKWWLPH&RROLQJ³Select the COOL mode

and LOW fan with a middle set temperature.

NOTE: There will be a 3-minute delay between setting

changes such as COOL to OFF and back to COOL.

FAN

Use the FAN to provide air circulation and filtering without

cooling or heating. Since fan only settings do not provide

cooling or heating, a temperature setting will not be displayed.

Remote Control

Press FAN pad. Press LOW or HIGH pads to set desired fan

speed.

Control Panel

Press the MODE pad until the FAN indicator light is lit

and the LOW or HIGH indicator light is lit for the desired fan

speed.

HEAT MODE

Remote Control

1. Press HEAT pad.

2. Press LOW or HIGH pads to set desired fan speed.

3. Press the ,1&5($6('(&5($6(²pads to set the desired

temperature 60°F to 85°F in 1°F increments.

Control Panel

1. Press the MODE pad until the HEAT indicator light is lit.

2. Press the FAN pad until HIGH or LOW indicator light

is lit for desired fan speed.

3. Press the ,1&5($6('(&5($6(²pads to set the

desired temperature 60°F to 85°F in 1°F increments.

A thermostat is used to maintain the room temperature. The

heater will cycle on and off to keep the room

at the set level of comfort. Set the thermostat at a higher

number and the indoor air will become warmer.

Set the thermostat at a lower number and the indoor air will

become cooler.

NOTE: If the air conditioner is off and is then turned on while set

to HEAT, it will take approximately 1 minute

for the heater to start and heating to begin.

Heating Descriptions

)RU1RUPDO+HDWLQJ³Select the Heat mode and HIGH fan

with a middle set temperature.

)RU0D[LPXP+HDWLQJ³Select the HEAT mode

and HIGH fan with a higher set temperature.

)RU4XLHWHUDQG1LJKWWLPH+HDWLQJ³Select the HEAT mode

and LOW fan with a middle set temperature.

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Comments to this Manuals

No comments

Ge AJCQ08ACF User Manual Page 7

Comments to this Manuals

Related products and manuals for Conditioners Ge AJCQ08ACF