GE Line Fit Light-LED (LFL-LED)
Fluorescent Box Sign Retrot
LED Lighting System
GE
Lighting
Installation Guide
imagination at work
24
Volt
(GEF18T12xxxHOLED, GEF24T12xxxHOLED, GEF30T12xxxHOLED, GEF36T12xxxHOLED,
GEF42T12xxxHOLED, GEF48T12xxxHOLED, GEF60T12xxxHOLED, GEF64T12xxxHOLED,
GEF72T12xxxHOLED, GEF84T12xxxHOLED, GEF96T12xxxHOLED)*
* key for xxx: D = Daylight (6500K), SGN = Sign White (5400K), CW = Cool White (4100K)
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
WARNING/AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground Tetra
®
power supply enclosure.
RISK OF FIRE
• Use only UL certied wire for input/output connections.
Minimum size 18 AWG (0.82mm
2
).
• Follow all NEC and local codes.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant l’inspection, l’installation ou le déplacement.
• Assurez-vous de correctement mettre à terre l’alimentation électrique Tetra
®
.
RISQUES D’INCENDIE
• N’utilisez que des ls approuvés par UL pour les entrées/sorties
de connexion. Taille minimum 18 AWG (0.82mm
2
).
• Respectez tous les codes NEC et codes locaux.
CAUTION/ATTENTION
RISK OF INJURY
• While performing installations described, gloves, safety glasses
or goggles should be worn.
RISQUE DE BLESSURE
• Lors de l’exécution des installations décrites, des gants, des lunettes de
sécurité ou des lunettes de protection doivent être portées.
Prepare Electrical Wiring
Electrical Requirements
• Limited to use in dry and damp locations.
• The grounding and bonding of the LED Driver shall be done in
accordance with National Electric Code (NEC) Article 600.
• Follow all National Electric Codes (NEC) and local codes.
• These products are only suitable for connection to a circuit
from a Class 2 power source. These products have not been
evaluated for use when connected to a power source that does
not comply with Class 2 voltage and energy limited supplies.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to
correct the interference at his own expense.
Comments to this Manuals