GE Level Crossing Installation Guide download pdf

Installation Instructions

RG6 Pixelated LED Signals – 12’’ (300mm) – Railway Grade Crossing

(Impact Test Resistance Lenses)

Operating Specifications:

Nominal Input Voltage:

10V AC/DC

Voltage Range:

8V to 14V AC/DC

Nominal Power Consumption:

8.4W (DC)

10.7W (AC)

 Always use a sun shielding apparatus such as a visor or hood over the signals.

 Do not attempt to open the LED module. No assembly is required.

 Performance and behavior of the lamp (including sidelights) is guaranteed only when operated in the voltage

range stated above.

Testing:

When testing the lamp before installation, first check the electrical characteristics on the label on the back of the lamp

(see box “B” below) to avoid damaging the lamp.

Installation Steps:

NOTE: Failure to properly follow these instructions may cause signal to malfunction.

1. Remove the incandescent bulb, reflector and lens assembly from the housing.

2. Feed wires of the LED signal module through the conduit in the housing.

3. Insert the LED signal into the lens slot and rotate it until the arrow on the back of the module (A) is aligned with

the top of the housing.

4. Lock the LED signal module in place by tightening metal tabs over the rim of the module, or fastening a ring

holder over the module, as applicable.

5. Connect the wires to the AAR terminals.

…Page 2

Visor / Hood

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Prepare Electrical Wiring

Electrical Requirements

 Do not use in wet locations

 Follow all National Electric Codes

(NEC) and local codes.

WARNING / AVERTISSEMENT

Risk of Electric Shock. Disconnect Before Servicing or installing product.

Risque de choc électrique. Couper l’alimentation avant le dépannage ou avant

l’installation du produit.

1 2

Summary of Contents

Page 1 - WARNING / AVERTISSEMENT

Installation Instructions RG6 Pixelated LED Signals – 12’’ (300mm) – Railway Grade Crossing (Impact Test Resistance Lenses) Operating Specif

Page 2 - Risk of Electric Shock

Installation Instructions (cont’d) RG6 Pixelated LED Signals – 12’’ (300mm) – Railway Grade Crossing This product is intended

Comments to this Manuals

No comments

GE Level Crossing Installation Guide

Browse online or download Installation Guide for Projector lamps GE Level Crossing. GE Level Crossing Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Projector lamps GE Level Crossing