GE miniMAX MS Installation Guide download pdf

imagination at work

Tetra

miniMAX

LED Lighting System

(GEMM71-2, GEMM50-2, GEMM41-2, GEMM32-2, GEMMRD-1, GEMMGL-1,

GEMMBL-1, GEMMPO-1)

Lighting Solutions

Installation Guide

Volt

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground Tetra

power supply enclosure.

RISK OF FIRE

• Use only UL approved wire for input/output connections.

Minimum size 18 AWG (0.82mm

)

• Follow all NEC and local codes.

WARNING/AVERTISSMENT

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant l’inspection, l’installation ou le

déplacement.

• Assurez-vous de correctement mettre à terre l’alimentation

électrique Tetra

RISQUES D’INCENDIE

• N’utilisez que des ls approuvés par UL pour les entrées/sorties

de connexion. Taille minimum 18 AWG (0.82mm

)

• Respectez tous les codes NEC et codes locaux.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Prepare Electrical Wiring

Electrical Requirements

• Do not use in wet locations.

• The grounding and bonding of the LED Driver shall

be done in accordance with National Electric Code (NEC)

Article 600.

• Follow all National Electric Codes (NEC) and local codes.

Save These Instructions

Use only in the manner intended by the manufacturer.

If you have any questions, contact the manufacturer.

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Note: This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment

is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual,

may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to

correct the interference at his own expense.

1 2 3 4

Summary of Contents

Page 1 - miniMAX

imagination at workTetra® miniMAXLED Lighting System(GEMM71-2, GEMM50-2, GEMM41-2, GEMM32-2, GEMMRD-1, GEMMGL-1, GEMMBL-1, GEMMPO-1)GELighting Solutio

Page 2 - Layout Modules

Measure and cut Tetra LED strip to the appropriate length for each letter. Cuts can be made between any of the modules.Remove tape backing and stick L

Page 3 - Retrot Instructions

To power supply Red (+)Black or blue (-)Red Stripe (+)White (-)Cap wiresConnect LED strips using in-line (IDC) connectors or twist-on wire connectors.

Page 4 - Troubleshooting

GE2020-8748SIGN093-R022614GE Lighting Solutions • 1-888-MY-GE-LED • www.gelighting.com1-888-69-43-533GE Lighting Solutions, LLC is a subsidiary of t

Comments to this Manuals

No comments

GE miniMAX MS Installation Guide

Browse online or download Installation Guide for Power extensions GE miniMAX MS. GE miniMAX MS Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Power extensions GE miniMAX MS