1Monogram.We bring good things to life.®If you have questions, call 800-GE-CARES or visit our website at: www.monogram.comInstallationInstructions30&q
10STEP 3 208V ELECTRICAL SUPPLYWARNINGThese ovens are pre-wired for connection to 240 volt,60 HZ, supply. If connecting to a 208 volt supply,modifica
11Installation InstructionsSTEP 4 REMOVE OVEN DOOR(S)• Open the door fully.• Push hinge latches up to lock hinges in openposition.STEP 5 ROUTE CABLE
12Installation InstructionsSTEP 6 SECURE OVEN TOCABINET• Slide oven into cabinet opening.• Drill 3/32" pilot holes through the oven front framea
13Installation InstructionsSTEP 8 CONNECT ELECTRICALWARNINGELECTRICAL SHOCK HAZARD• Electrical ground is required onthis appliance.• DO NOT connect t
14Installation InstructionsINSTALLATION CHECKLIST1. Turn all knobs to OFF or Normal.2. Turn on power at the circuit breaker.3. Set the clock for curre
16Note: While performing installations described in this book,safety glasses or goggles should be worn.For Monogram® local service in your area, call1
2Installation InstructionsCAUTION:Due to the weight and size of these wallovens and to reduce the risk of personal injury ordamage to the product, TWO
3Installation InstructionsPRODUCT DIMENSIONSSingle OvensCONTENTSProduct InformationProduct Dimensions...
4CabinetryFramed Cabinet, Single ovenOrder a 30" oven cabinet with the cutout sized to fitthe single oven.• These ovens require 3/4" overlap
5CabinetryInstallation Over a Monogram Warming DrawerSingle OvenNOTE: Additional clearances between cutouts maybe required. Check to be sure the oven
6CabinetryInstallation Below aMonogram Advantium OvenNOTE: The middle rail separating the two openingsmay need to be larger than the 2" minimum s
7Installation PreparationELECTRICAL REQUIREMENTSThese Monogram built-in ovens require a separateproperly grounded 3-wire 120/208 or 120/240 volt, 60Hz
8Installation PreparationPROVIDE OVEN SUPPORTSOvens may be supported by either a solid bottom orby 2 x 4 runners.• The support must be level and rigid
9WARNINGELECTRICAL SHOCK HAZARD• The electrical power to the ovenbranch circuit must be shut-offwhile line connections are beingmade.• Use copper wiri
Comments to this Manuals