131-10595-2 1-07 JRBEFORE YOU BEGINRead these instructions carefully and completely.•IMPORTANT — Save theseinstructions for local inspector’s use.•IMP
INSTALL THE RANGE(CONT.)Carefully mark the cabinet for the location ofthe stop screws. Drill 1/8” pilot holes into thecabinet, each side of the range.
ATTACH THE LOWER TRIMAttach the lower trim (supplied separately withthe range) to the bottom of the vertical sidetrim with the 2 screws supplied.5CHEC
Lift the oven door by placing one hand on each side. The door is heavy, so you may need help. Do not lift the door by the handle.With the door at the
FINAL CHECKLIST• Check to make sure the circuit breaker is closed (Reset) or the circuit fuses are replaced.• Be sure power is in service to the build
WallMust beflatMust beflatMust belevelMust be level30”smooth cut9/16”9/16”25”ALTERNATE CONSTRUCTION PREPARATIONRefer to the Filler or Backguard Kit in
15Notes
Printed in the United States16Notes
FOR YOUR SAFETYWARNING: For personal safety,remove house fuse or open circuit breakerbefore beginning installation. Failure to do so could result in s
• Place hands on both sides of the door, and close the oven door to the removal position. This is half way between the broil stop and fully closed.• L
PRE-INSTALLATION CUTOUT AND REQUIRED CLEARANCESIf cabinets are placed less than 30” min. above the range, seealternate construction.30” ranges conform
The Standard Installation of this Drop-In Rangeis to hang by the countertop on the side metalflanges under cooktop. This Range must not be installed o
Remove house fuse or open circuit breaker.Loosen screws for the junction box coverand rotate out of place or remove thecover.Examine the junction box
THREE-CONDUCTOR BRANCH CIRCUIT CONNECTIONWhen connecting to a 3-conductor branch circuit, if local codes permit:Connect the bare oven ground conductor
Do not shorten the flexible conduit. The conduit strain relief clamp must be securely attached tothe junction box and the flexible conduit must be sec
Select the proper position for the countertopthickness and move bracket to proper position.(Unit is supplied with bracket in position 1.)INSTALL THE R
Comments to this Manuals